MarCablo S
Series 17 115

Cable printing


Ready to use special ink for printing onto insulated electric wires with PVC

Basis Solvent based synthetic resin
Application method Gravure printing e.g. Medek + Schörner KS or RSD Technik GmbH
Form of supply All international colour shades e.g. RAL, IEC 304 and also metallic shades available
Technical Data
Solid content15 - 40%depending on the shade ISO 3251
Density0,95 - 1,30 g/cm³depending on the shade ISO 2811-1 at 23°C
Viscosity45"/4 mmEN ISO 2431 at 23°C
Flash point30°C - 38°Cdepending on the shade ISO 1523
PreparationStir before use
DilutionHERKULA special thinner 17 287 to readjust the viscosity in the machine. Amount of thinner depends on the machine.
CuringIt is advisable to mark onto the hot plastic insulation. Therefore, the marker should be placed as close as possible to extruder.
Process speed300 m/min to 1000 m/min
CleaningHERKULA special cleaning agent 35014
Shelf life: 2 years (except special colours) in a well closed can, Standard Packaging: 10 L can (other packaging on request)
Observe your Material Safety Data Sheet as well as the instructions on the label
In case of polyethylene substrates a surface oxidation by corona pre-treatment is necessary in order to achieve good adhesions. It is advisable to pre-cool the plastics material after extrusion by means of ambient air or water jet (residual water must be blown of).
  • No influence on the electrical characteristics
  • Resistance to "bleeding"
  • Pigments are free of lead and other heavy metal
  • Version: 15/02/2016
    Export Data Sheet